A SERVICE OF

logo

114 Removing and replacing parts Q1860-90918
Fuser
1 Remove the rear door and rear output bin (see page 113).
2 Facing the back of the printer, remove the two machine screws (callout 1) that hold the fuser
in the chassis.
3 Insert a small, flat-blade screwdriver under the fuser (at callout 2), and lift to disengage the
fuser assembly detents.
4 Grasp the green pressure-release handles (callout 3) and pull the fuser out of the chassis.
Note The fuser power connection is on the left side of the assembly.
Figure 39. Fuser removal (rear view of printer)
2
2
2
2
3
1
www.GovTechMedia.com