Filter
Top Products
Administering the ARP Cache 9-13
To statically configure the default route:
1 From the top level of the Administration Console, enter:
ip route default
2 Enter the gateway IP address of the route.
The default route is immediately added to the routing table.
Removing the
Default Route
To remove a default route, enter the following command string from the
top level of the Administration Console:
ip route noDefault
The default route is immediately removed from the routing table.
Administering
the ARP Cache
The LANplex system uses the Address Resolution Protocol (ARP) to find the
MAC addresses corresponding to the IP addresses of hosts and routers on
the same subnets. An ARP cache is a table of known IP addresses and their
corresponding MAC addresses.
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
➧route
arp
atmArpServer
multicast
udpHelper
routing
icmpRouterDiscovery
rip
ping
statistics
display
static
remove
flush
➧default
noDefault
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
interface
➧route
arp
multicast
atmArpServer
udpHelper
routing
icmpRouterDiscovery
rip
ping
statistics
display
static
remove
flush
default
➧noDefault