Filter
Top Products
Administering interfaces 9-5
The Console prompts you for the interface’s parameters. To use the value in
brackets, press [Return] at the prompt.
2 Enter the IP address of the interface.
3 Enter the subnet mask of the network to which the interface is to be
connected.
4 Enter the cost value of the interface.
5 Enter the type of IP interface: LIS.
6 Enter the advertisement addresses for this interface. You can enter up to 32
advertisement addresses for each interface. (The maximum number on the
LANplex system is 64.)
7 Enter the LIS information:
■ For a LIS interface with SVCs, enter the ATM ARP server address, the
maximum SVC count, the inactivity timer, the minimum holding time,
and the ATM port associated with the interface. (You can also accept the
defaults for these values.)
■ For a LIS interface with only PVCs, enter the ATM port and the PVCs
associated with the interface. You can enter up to 51 PVCs for each
interface. (The maximum number on the LANplex system is 64.)
LIS interface example with both PVCs and SVCs:
Enter IP address: 158.101.1.1
Enter subnet mask [255.255.0.0]: 255.255.255.0
Enter cost [1]:
Enter interface type (vlan,lis) [lis]:
Enter advertisement address(es) []:
158.101.112.1
Enter ATM arp server address
[00-0000-00-000000-0000-0000-0000-000000000000-00]:
47-0000-00-000000-000
00000-00cc -000000000001-ff
Accept completed ATM address (yes,no) [yes]:
Enter max. SVC count (0=no max.0) [0]:
Enter inactivity time (0=infinite, 10-10000) seconds [1200]:
Enter min. holding time (0-10000) seconds [60]:
Select ATM port [1]:
Enter PVC(s) (VPI/VCI)[]: 1/32,1/200,1/3330