Filter
Top Products
9-4 CHAPTER 9: ADMINISTERING IP ROUTING
Example summary display:
Example detail display:
Defining an IP LIS
Interface
When you define an IP LIS interface, you specify several general IP interface
characteristics and IP LIS characteristics.
Before you define an IP LIS interface with SVCs, be sure you have defined an
ATM ARP server as described in the section “Administering ATM ARP Servers”
later in this chapter. If the LIS interface has only PVCs, you do not need to
define an ATM ARP server.
To define an IP interface:
1 From the top level of the Administration Console, enter:
ip interface define
IP routing is enabled, RIP is active,
ICMP discovery is disabled.
Index Type IP address Subnet mask Cost State VLAN Index
1 VLAN 158.101.1.1 255.255.255.0 1 Down 2
2 LIS 158.101.112.1 255.255.255.0 1 Up 1
Index Type IP address Subnet mask Cost State Port
IP forwarding is enabled, RIP is active,
ICMP discovery is disabled.
Index Type IP address Subnet mask Cost State VLAN index
1 VLAN 158.101.1.1 255.255.255.0 1 Down 2
Index Type IP address Subnet mask Cost State Port
2 LIS 158.101.112.1 255.255.255.0 1 Up 1
4 Advertisement Addresses:
158.101.112.200 158.101.112.203 158.101.112.204 158.101.112.205
atmArpServer
47-0000-00-000000-0000-0000-00cc-080001200054-ff
maxSvcCount inactivityTime minHoldingTime
0 1200 60
1PVC:
1/32
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧ip
ipx
appletalk
snmp
analyzer
script
logout
➧interface
route
arp
atmArpServer
multicast
udpHelper
routing
icmpRouterDiscovery
rip
ping
statistics
summary
detail
➧define
modify
remove
addAdvertisement
removeAdvertisement
addPVC
removePVC