Filter
Top Products
Administering Servers 11-9
Displaying the
Server Table
You can display the server table for the system to determine which
servers are learned and if they are operational.
To display the contents of the server table, from the Administration
Console top-level menu, enter:
ipx server display
Defining a Static
Server
Before you define static servers on the system, you must define at least
one IPX interface. See the section “Defining an IPX Interface” on
page 11-3. Static servers remain in the table until you remove them or
until you remove the corresponding interface. Static servers take
precedence over dynamically learned servers to the same destination.
You can have a maximum of eight static servers.
To define a static server:
1 From the Administration Console top-level menu, enter:
ipx server static
2 Enter the interface number of the server.
3 Enter the service type of the server.
4 Enter the service name of the server.
5 Enter the IPX network address of the server.
6 Enter the socket value of the server.
7 Enter the node address of the server.
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
➧server
forwarding
rip
enhanced
sap
statistics
➧display
static
remove
flush
IPX forwarding is enabled, RIP is active, SAP is active
Interface Name Type Network Node Socket Hops Age
2 GB201 39b 8c141bfe 08-00-02-04-80-b6 8059 4 73
2 GB3COM2 39b af0bc60f 00-00-00-00-00-01 85fa 4 85
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧ipx
appletalk
snmp
analyzer
script
logout
interface
route
➧server
forwarding
rip
enhanced
sap
statistics
display
➧static
remove
flush