Filter
Top Products
Administering Interfaces 12-3
Displaying
AppleTalk Interfaces
You can display a table that shows all AppleTalk interfaces and their
parameter settings configured for the system.
To display the AppleTalk interfaces defined on the router, from the
Administration Console top-level menu, enter:
appletalk interface display
Example:
Defining an
Interface
When you define an interface, you define the interface’s network range,
zone name, and the VLAN index associated with the interface. You must
define an AppleTalk VLAN before you define the AppleTalk interface to
associate with that VLAN.
To define an AppleTalk interface:
1 At the Administration Console’s top-level menu, enter:
appletalk interface define
You are prompted for the interface’s parameters. To use the value in
brackets, press [Return] at the prompt.
The following message appears:
Configure seed interface? (n,y) [y]:
2 Enter n (no) or y (yes).
3 Enter the start of the network range associated with the interface.
4 Enter the end of the network range associated with the interface.
5 Enter the default zone name.
The default zone name is used by clients that have not been configured to
use a particular zone.
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
ipx
➧appletalk
snmp
analyzer
script
logout
➧interface
route
aarp
zone
forwarding
checksum
ping
statistics
➧display
define
remove
DDP forwarding is enabled.
Index Network Range Address State VLAN index
1 20112-20112 20112.27 enabled 3
2 20124-20124 20124.1 enabled 2
3 20125-20125 20125.1 enabled 4
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
ipx
➧appletalk
snmp
analyzer
script
logout
➧interface
route
aarp
zone
forwarding
checksum
ping
statistics
display
➧define
remove