Filter
Top Products
CLI Commands B-13
DIAL
dial <vc_name> Generates an outgoing connection to the location specified by the vc name. You
can use list vcs to list the defined vc profiles, and their current status.
DISABLE
disable access Disables the Access List feature. When disabled, all hosts are permitted to access
the Router’s management services.
disable bridge network
<name>
Disables the bridge network you previously defined using the add bridge network
command. You can see which bridge networks are currently running using list
bridge forwarding.
disable bridge
spanning_tree
Disables use of the spanning tree algorithm on bridge networks. The spanning
tree algorithm is required if there is more than one bridge between the same two
LAN segments. You can use list bridge forwarding to see which bridges are
defined, and show bridge network settings to see which options are enabled on a
particular bridge network.
disable command
password
Disables the console password feature.
disable icmp Disables the Internet Control Message Protocol.
disable interface
<interface_name>
Disables the specified interface. A disabled interface remains in the interface table,
but will not transmit or receive any data. Use list interfaces to see the currently
defined interfaces, and their status.
disable ip forwarding Causes the system to stop forwarding any packets over IP networks.
disable ip network
<network_name>
Disables the specified IP network. Make sure there is no activity on this network
before disabling it.
disable ip rip Disables the RIP routing algorithm on all IP networks. You can use show ip routing
to see the current status of IP routing. This saves system space by preventing a
large RIP database, which is useful for networks connecting over the WAN
interface.
disable ip routing Disables all routing protocols on all IP networks. Currently, the only routing
protocol is RIP, which means that disable ip rip performs the same function. Use
show ip routing to see the current status of IP routing.
disable ip
static_remote_routes
Disables all statically defined remote routes on all IP networks, that you previously
defined using add ip route. You can list the current IP routes using list ip routes.
disable ipx network
<network_name>
Disables the specified IPX network. Use list ipx networks to see which IPX
networks are defined, and their current status.