Filter
Top Products
6-16 CHAPTER 6: MANUAL SETUP
You can obtain a list of all configured networks using the command list
networks. To only list IP networks, use list ip networks.
By default, the network is enabled when it is created. You can disable the
network using the following command:
disable ip network <network name>
You can delete a disabled network using the command:
delete ip network <network name>
The reconfigure ip network command can be used to modify an existing IP
network’s address or frame type.
Configuring IP RIP on
the LAN
IP RIP is configurable on each LAN IP network. The OCR 812 supports two versions
of RIP, V1 or V2. You can also disable RIP completely.
To set enable/disable RIP or set the version to use for a particular LAN IP
network, use the command:
set ip network <network name>
routing_protocol [NONE | RIPV1 | RIPV2]
Other permutations of the set ip network command can be used to configure
advanced RIP features and policies.
Configuring IP for the
Remote Site Connection
In order to enable IP to be routed to a remote site, you must configure the
following items in the VC profile associated with the remote site connection.
You must enable IP routing in the profile
You must enter the remote IP address information
You must enter the local IP address information
To enable or disable IP routing in a VC profile, use the command:
set vc <vc name>
ip [DISABLE | ENABLE]
The remote IP address information consists of the IP address of the router at the
other end of the VC connection. This address can be either specified by you, or (if
you are using PPP as the Network Service for the connection) it can be learned
when the PPP session is established.
To specify the remote IP address, use the command:
set vc <vc name>
remote_ip_address <ip address/mask>
To specify that the remote IP address should be learned you can enter
255.255.255.255/H for the <ip address/mask> parameter, or you can use the
command:
set vc <vc name>
address_selection negotiate