Filter
Top Products
4-2 CHAPTER 4: QUICK SETUP
Downgrading the Remote 812 Software to a Previous Version
Downgrading the 812 software to an older version is not recommended (we
suggest you upgrade to obtain the latest and most reliable software available).
If you do choose to downgrade, we suggest you delete your existing configuration
before or after you install the downgrade (in any case, you must delete the
existing configuration).
Installation of a downgraded version of the Remote 812 software (a version older
than the version currently installed) is likely to cause a reduction in functionality.
The reduction in functionality you experience may be substantial or minor,
depending on which version you have before the downgrade, and which version
you downgrade to.
Quick Setup Script
Instructions
The following sections contain the CLI Quick Setup script. You will be required to
enter information concerning your network configuration. Questions in the script
are presented here in tables. Write the appropriate information for your desired
configuration in the tables appearing throughout this section.
Quick Setup (CLI) is designed only for initial set up of the OCR 812. When setup is
complete, this one-time program will alter your configuration files (which the
program cannot edit). If you make an error and need to restart, use the delete
configuration command to reboot and return to factory default settings.
Quick
Setup Script The OCR 812 Quick Setup will let you set up LAN-side and global configuration
for your system.To configure wide-area profiles you should run the OCR 812 VC
Wizard using the QUICKVC command.
Do you want to continue Quick Setup?
The OCR 812 Quick Setup allows you to set up a simple configuration for IP, IPX,
and bridging.
Please answer the questions presented below with "yes" or "no" to indicate which
portions of the system you want to configure.
When Quick Setup displays a question it will display a default answer in square
brackets, like "[yes]". If you simply press enter, this is the answer that will be used
for you.
Password Protection
Which portions of the network do you want to configure?
Question Default Your System
Do you want the CLI to be password
protected?
[no]
What is the console login password (no
more than 8 characters)?
[ ]
Question Default Your System
Network management ? [yes]
IP ? [yes]