Filter
Top Products
CLI Commands B-35
set user <user_name> message [“message”]
password [password]
session_timeout [seconds]
tcp_port [tcp_port]
terminal_type
Modifies user parameters.
SEND_PASSWORD <password> The SEND_PASSWORD
must match the
authentication password
on the VPN server. You
must change the default
SEND_PASSWORD using
the SET TUNNEL
command.
ENCRYPTION_ALGORITHM NONE
AUTO
MICROSOFT_128BIT
MICROSOFT_40BIT
MICROSOFT_56BIT
REQUIRED
MTU 1400
SEND_NAME <name> The SEND_NAME must
correspond with the
authentication name on
the VPN server. If you do
not specify <name>, the
system sets the value for
this field to <tunnel
name>.
NAT_OPTION PAT
LOCAL_IP_ADDRESS <ip_address> 255.255.255.255 is the
recommended setting for
LOCAL_IP_ADDRESS
REMOTE_IP_ADDRESS <ip_address> 255.255.255.255 is the
recommended setting for
REMOTE_IP_ADDRESS
Table 6-7 812 Set Tunnel Parameters and Supported Values
Parameter Supported Value Remarks
Parameter Description
<user_name> Name of user, previously defined using add user. Limit of 32 characters.
message Message presented to a dial-in user.
password User’s password, up to 15 ASCII characters. Value is required.