Filter
Top Products
CLI Commands B-27
set facility
<facility_name>
loglevel [level]
Sets the severity reporting level for a facility. The hosts that will receive the error
log entries are defined using add syslog loglevel. Use list facilities to see what the
current loglevel is for each facility. The levels:
CRITICAL - a serious system error, which may effect system integrity
UNUSUAL - an abnormal event, which the system should recover from
COMMON - a regularly occurring event that is not frequent
VERBOSE - a regular periodic event, e.g. a routing update message
DEBUG - for debugging purposes only
set ilmi vpi <number>
vci <number>
This allows modification of the Virtual Path or Channel ID that will be used for
exchanging ILMI (Integrated Local Management Interface) messages.
set interface
<interface_name>
filter_access [ON | OFF]
input_filter <filter_name>
output_filter <filter_name>
Sets filter parameters for the specified protocol on the specified interface. You can
see the available filter files using list filters, view the contents of a filter file using
show filter, and add filter files to FLASH memory using TFTP.
set ip network <name> broadcast_algorithm [number]
reassembly_maximum_size [number]
rip_authentication [string]
rip_policies_update <rip_policies>
routing_protocol [NONE | RIPV1 | RIPV2]
timeout Number of seconds to wait before deciding a request to a Name Server has
timed out. Minimum interval and default is 5 seconds, maximum interval is
120 seconds.
Parameter Description
vpi The virtual path identifier for the ILMI.
vci The virtual channel identifier for the ILMI.
Parameter Description
<interface_name> Designation of interface you are setting parameters for. Limit of 32
characters.
filter_access ON causes filters specified for an interface with a set interface command,
to override filters specified with a set user command, when the filters are
of the same type.
input_filter Name of filter file you wish to be applied to the input stream coming in on
the specified interface. Limit: 20 characters.
output_filter Name of the filter file you wish to be applied to the output stream leaving
the specified interface. Limit: 20 characters.