Filter
Top Products
135
Talk Set
This function allows you to use the 965DSP as a
Talk Set on active pairs or to send DTMF tones on
inactive pairs.
Connect the red and black leads to the pair for lines
using Loop Start. Also connect the green lead to
ground on Ground Start lines.
This screen displays the last number dialed, the DC
voltage on the line, and the signal format for dialing.
The blue keys become number keys in the Talk Set.
Use the [Setup] key to change the Dial or Start mode
or to select and edit a stored phone number (see Talk
Set Setup page 136).
Use the [Tab] key to switch between on-hook and
off-hook.
Use the [Enter] key to dial the number in the display.
You may also manually enter numbers and they will be
sent out on the line. You may also get a stored number
from memory
(see Talk Set Setup page 136)
and then
send it.
Note: Pulse dial can only be used “on-hook.”
Use the [Right] arrow key to turn the microphone
on and off. Use the [Up] and [Down] arrow keys to
adjust the volume. The maximum volume is limited
in the Talk Set function to prevent unwanted feedback
(squealing).
Use the [Return] key to exit the Talk Set before going
to another function.