Filter
Top Products
66
Press [Enter] to accept the changes for the section
and return to the previous RFL Setup screen. Press
[Return] to return without making changes.
Edit Section Information
If you choose to edit the Section information (gauge
or distance) for any of the six sections, use the [Up]
and [Down] keys to select the desired section, then
press the [Setup] key to edit the selected section.
Press the [Tab] key to select either the Wire Gauge
menu or the Section Length.
If you select the Wire Gauge menu, press the [Up]
and [Down] keys to select the desired gauge.
If you select Section Length, enter the length of the
section using the blue keys.
Note: If you are using less than the maximum of
six sections, the distance of all unused sections is
set to zero feet or meters.
You will see the message “Enter ‘#’ if unknown”
below the Edit Section Length if the temperature or
another section has not previously been declared as
unknown. Declare a section “unknown” by entering
a “#” in the length box.