Accton Technology ES3628C Switch User Manual


 
Configuring the Switch
3-88
3
Web – Click Security, ACL, Port Binding. Mark the Enable field for the port you want
to bind to an ACL for ingress or egress traffic, select the required ACL from the
drop-down list, then click Apply.
Figure 3-51 ACL Port Binding
CLI – This examples assigns an IP and MAC ingress ACL to port 1, and an IP
ingress ACL to port 2.
Port Configuration
Displaying Connection Status
You can use the Port Information or Trunk Information pages to display the current
connection status, including link state, speed/duplex mode, flow control, and
auto-negotiation.
Field Attributes (Web)
Name – Interface label.
Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)
Admin Status – Shows if the interface is enabled or disabled.
Oper Status – Indicates if the link is Up or Down.
Speed Duplex Status – Shows the current speed and duplex mode.
(Auto, or fixed choice)
Flow Control Status – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or None)
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
Console(config)#interface ethernet 1/1 4-143
Console(config-if)#ip access-group david in 4-98
Console(config-if)#mac access-group jerry in 4-105
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#ip access-group david in
Console(config-if)#