Filter
Top Products
Command Line Interface
4-250
4
ip proxy-arp
This command enables proxy Address Resolution Protocol (ARP). Use the no form
to disable proxy ARP.
Syntax
[no] ip proxy-arp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
Proxy ARP allows a non-routing device to determine the MAC address of a
host on another subnet or network.
Example
IP Routing Commands
After you configure network interfaces for this router, you must set the paths used to
send traffic between different interfaces. If you enable routing on this device, traffic
will automatically be forwarded between all of the local subnetworks. However, to
forward traffic to devices on other subnetworks, you can either configure fixed paths
with static routing commands, or enable a dynamic routing protocol that exchanges
information with other routers on the network to automatically determine the best
path to any subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to connect
the router to the enterprise network.
Console(config)#interface vlan 3
Console(config-if)#ip proxy-arp
Console(config-if)#
Table 4-82 IP Routing Commands
Command Group Function Page
Global Routing
Configuration
Configures global parameters for static and dynamic routing, displays the
routing table, and statistics for protocols used to exchange routing
information
4-251
Routing Information
Protocol (RIP)
Configures global and interface specific parameters for RIP 4-256
Open Shortest Path First
(OSPF)
Configures global and interface specific parameters for OSPF 4-266