Filter
Top Products
Interface Commands
4-143
4
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enter interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit
41
. (Range: 1-1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
• vlan vlan-id (Range: 1-4094)
Default Setting
None
Table 4-48 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-143
description Adds a description to an interface configuration IC 4-144
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-144
negotiation Enables autonegotiation of a given interface IC 4-145
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-146
flowcontrol Enables flow control on a given interface IC 4-147
shutdown Disables an interface IC 4-148
switchport broadcast
packet-rate
Configures the broadcast storm control threshold IC 4-148
clear counters Clears statistics on an interface PE 4-149
show interfaces status Displays status for the specified interface NE, PE 4-150
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-151
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-152
41. Stacking is not supported in the current firmware.