Accton Technology ES3628C Switch User Manual


 
Configuring the Switch
3-268
3
Web – Click Routing Protocol, DVMRP, General Settings. Enable or disable
DVMRP. Set the global parameters that control neighbor timeout, the exchange of
routing information, or the prune lifetime, and click Apply.
Figure 3-149 DVMRP General Settings
CLI – This sets the global parameters for DVMRP and displays the current settings.
Configuring DVMRP Interface Settings
To fully enable DVMRP, you need to enable multicast routing globally for the router
(page 3-261), enable DVMRP globally for the router (page 3-265), and also enable
DVMRP for each interface that will participate in multicast routing.
Command Attributes
DVMRP Interface Information
Interface – VLAN interface on this router that has enabled DVMRP.
Address – IP address of this VLAN interface.
Metric – The metric for this interface used to calculate distance vectors.
Status – Shows that DVMRP is enabled on this interface.
Console(config)#router dvmrp 4-301
Console(config-router)#probe-interval 30 4-302
Console(config-router)#nbr-timeout 40 4-303
Console(config-router)#report-interval 90 4-303
Console(config-router)#flash-update-interval 10 4-304
Console(config-router)#prune-lifetime 5000 4-304
Console(config-router)#default-gateway 10.1.0.253 4-305
Console(config-router)#end
Console#show router dvmrp 4-307
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway :
Console#