Filter
Top Products
Setup 4-7
4.4 Advanced System Configuration
The Advanced System Configuration section has a three-page screen
display. The first two pages of this section are accessible with m as well as
the no-reboot Setup button ( ). The third page is accessible only with the
no-reboot Setup button. The following is page 1.
Advanced System Configuration
PgDn/PgUp = Move Screen, F1 = Help, Esc = Exit
Page 1/3
Power Management Mode ---------------------- [Enabled]
Display Standby Timer ------------------- [ 1] Minute(s)
Battery-low Warning Beep ------------------- [Enabled]
Suspend upon Battery-low ------------------- [Enabled]
Password Check during Resume --------------- [Disabled]
→ ←↑ ↓
= Move Hightlight Bar, = Change Setting
Hard Disk Standby Timer ----------------- [ 1] Minute(s)
System Standby/Suspend Timer ------------ [ 3] Minute(s)
4.4.1 Power Management Mode
With this parameter set to [Enabled], all the timers in Setup take effect
unless specifically disabled by the user. Select [Disabled] to turn off all
the timers.
If APM is installed under DOS or Windows, you cannot disable
the Power Management Mode under Setup. To disable APM,
type Power Off under DOS, or disable the Power icon in the
Windows Control Panel.