Filter
Top Products
:COMMunicate
:SERial[n] :CONTrol
:RTS?
SYSTem:COMMunicate:SERial[ n]:CONTrol:RTS? returns the current setting
for RTS line control.
Example Checking the setting of RTS control.
SYST:COMM:SER0:CONT:RTS?
enter statement statement enters the string
"ON ", "OFF", "S TA N ", or "IB F"
:COMMunicate
:SERial[n] [:RECeive]
:BAUD
SYSTem:COMMunicate:SERial[n][:RECeive]:BAUD < baud_rate> Sets the
baud rate for the serial port.
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
baud numeric 300 | 1200 | 2400 | 4800 |
9600 | 19200 | MIN | MAX
none
Comments • Attempting to set baud to other than those values shown will result in an
error -222.
• DIAG:BOOT:COLD will set …BAUD to 9600.
• *RST condition: No change.
Example Setting the baud rate to 1200.
SYST:COMM:SER0:BAUD 1200
:COMMunicate
:SERial[n] [:RECeive]
:BAUD?
SYSTem:COMMunicate:SERial[n][:RECeive]:BAUD? [MIN | MAX] returns:
• The current baud rate setting if no parameter is sent.
• The maximum allowable setting if MAX is sent.
• The minimum allowable setting if MIN is sent.
Example Querying the current baud rate.
SYST:COMM:SER0:BAUD?
enter statement statement enters a numeric
value
SYSTem :COMMunicate :SERial[n] :CONTrol :RTS?
System Instrument Command Reference 7-39