Filter
Top Products
Using the WYSE
WY-30
With the WYSE
WY-30
terminal, some functions of the Display Terminal
Interface have been assigned to keys with other labels. Use this keyboard map to
help locate these functions.
The symbols shown in the upper left corner of key each are now mapped with
the function labeled in the center of each key.
Where two function key labels are shown, the one following the "/" character is
accessed by pressing and holding the CTRL key while pressing the desired
function key (e.g. to access the f6 function, press CTRL-f2/f6).
1
Using Other
Terminals
This section discusses using terminals which are not on the Supported Terminals
list. Primarily this section is to help you use terminals which do not provide
programmable soft keys (function keys). Without this capability, a terminal can
not access the Display Terminal Interface’s menus. Instead, the terminal
interface provides a set of Terminal Interface Commands which allow you to
select instruments by name or logical address. Once selected, you can type
Common Commands or SCPI commands to the instrument. In addition,
keyboard accessible control codes provide display control for terminals which
may not have keys dedicated to those functions.
Using the Display Terminal Interface 3-19