Filter
Top Products
Backup Services Commands
Page 34-3
Adding a Backup Service
With the bsadd command, you can:
• Add a backup for a physical port
• Back up a frame relay PVC
Adding a backup for a Physical Port
To add a backup service for a physical port:
1. Enter the
bsadd command with no parameters, followed by <return>.
/Interface/backup % bsa <return>
A screen similar to that shown below will display:
Adding Backup Service Index :1
1) Description : Backup 1
2) Admin Status { (E)nabled, (D)isabled } : Enabled
3) Primary Type { Physical Port (1),
Frame Relay PVC DLCI (2) } : Physical Port
30) Slot :
31) Port :
4) Backup Type { PPP Peer (1) } : PPP Peer
40) Peer ID :
5) Startup Timer Value { Time in Seconds after
System Startup to wait
for Primary to come up
before activating
Backup } : 300
6) Activate Timer Value { Time in Seconds after
Primary Failure to
activate Backup } : 30
7) Restore Timer Value { Time in Seconds after
Primary restoral to
disable Backup } : 30
(save/quit/cancel)
:
2. When you first enter the command, the next unique index is assigned automatically, a
default description is created (Backup followed by the new index number), and defaults
for primary type, backup type, and all backup timers are created (as shown above).
3. To back up a physical port, enter the numbers for the slot and port to be backed up and
the PPP peer index (which defines ISDN call and PPP parameters). Optionally, you can
modify the timer values (fields 5-7). Below is an example of backing up the port on slot 2,
port 1 with PPP peer index 5.