Filter
Top Products
Bridge Management Menu
Page 17-5
Bridging Commands. These commands allow you to view bridge forward tables, create and
view static address tables, display bridge port statistics, view MAC address information, view
remote trunking stations, and view the domain bridge mapping table. Commands in this
section include fwt, fs, fc, bps, macinfo, macstat, macclrstat, rts, and dbrmap. For more
information, see:
• Displaying Bridge Forwarding Table on page 17-8
• Configuring a Static Bridge Address on page 17-10
• Displaying Static Bridge Addresses on page 17-13
• Displaying Bridge Port Statistics on page 17-14
• Displaying Media Access Control (MAC) Information for a Specific MAC address on page
17-16
• Display Statistics of Bridge MAC Addresses on page 17-17
• Clear Statistics of Bridge MAC Addresses on page 17-18
• Display Remote Trunking Stations on page 17-18
• View the Domain Bridge Mapping Table on page 17-19
Setting Flood Limits. These commands allow you to configure and view flood limits for a
specific group using the flc and fls commands. For more information, see:
• Setting Flood Limits for a Group on page 17-21
• Displaying Group Flood Limits on page 17-22
Configuring Spanning Tree. These commands allow you to configure and view IEEE and IBM
Spanning Tree for a specific group, and include the stc, sts, stpc and stps commands. (The
stc and sts commands can also be used to configure and view Fast Spanning Tree for a
selected VLAN.) For more information, see:
• Configuring Spanning Tree Parameters on page 17-25
• Display Spanning Tree Bridge Parameters on page 17-28
• Configuring Spanning Tree Port Parameters on page 17-30
• Displaying Spanning Tree Port Parameters on page 17-32