Filter
Top Products
Bridge Management Menu
Page 17-4
Bridge Management Menu
To view the Bridge Management Menu, enter the br command at the system prompt. If you
are in verbose mode, the following table appears outlining the commands available to you. If
you are not in verbose mode, enter a ? at the prompt to display the Bridge Management
Menu.
Command Bridge Management Menu
--------------- ----------------------------------------------------------------------------------------------
fls Display Flood Limit of selected Group
flc Configure Flood Limit on selected Group
sts Display Spanning Tree parameters on selected Group
fstps Display Fast Spanning Tree port parameters on selected VLAN
actfstps Activate Fast Spanning Tree port parameters on selected VLAN
stc Configure Spanning Tree parameters on selected Group
stps Display Spanning Tree Port parameters on selected VLAN
stpc Configure Spanning Tree Port parameters on selected VLAN
srs Display Source Routing parameters on selected Group
src Configure Source Routing parameters on selected Group
srsf Enable or disable Source Routing SAP Filter Support
srtbcfg View and configure Source Route to Transparent Bridging
srtbrif View learned RIF from Source Route to Transparent Bridging Table
srtbclrrif View and Clear learned RIF from Source Route to Transparent
Bridging Table
fwt Display Bridge Forward table on selected VLAN
fs Display Bridge Static Address
fc Configure Bridge Static Address
bps Display Bridge Port Statistics on selected VLAN
macinfo Locate learned Bridge MAC address in this chassis
macstat Show statistics of Bridge MAC address
macclrstat Clear statistics of Bridge MAC address
selgp A Group can be selected for the bridge operations or to generate MIB
reports
rts Display remote Trunking Stations discovered
dbrmap View the Domain Bridge Mapping table
+ / - Select next / previous VLAN
Details on commands included in the Bridge Management Menu commands are given in the
following sections:
Setting the Default Group. These commands allow you to choose which group you are modify-
ing or viewing, and include the selgp, +, and - commands. For more information, see:
• Selecting a Default Group on page 17-7
• Using the + or - to Change Groups on page 17-7 for more information.