Filter
Top Products
General User Interface Guidelines
Page 4-25
Viewing Commands
If at any time you are not sure of the commands available, enter ? and you will be given a list
of the commands in the current sub-menu. Following each list of commands is a list of sub-
menus. You can go directly to any sub-menu in the list.
You can specify whether the full menu will be displayed when you enter a command for a
menu or sub-menu and the amount of information you receive when you run the help
command. (Refer to Setting Verbose/Terse Mode for the User Interface on page 4-22 for more
information.) Additionally, there is a lookup facility to assist with administrative tasks. You
can look up any command name or prefix as follows:
lookup vlans
or to see all commands starting with v use:
lookup v*
To see all commands available, enter:
lookup *
Changing Passwords
The pw command is used to change passwords and is described in Chapter 8, “Switch Secu-
rity.”