Filter
Top Products
Configuring IPX Serialization Packet Filtering
Page 27-27
5. Filtering will then become active. A message will appear indicating that IPX Serialization
Filtering is enabled, either on all WAN routing services or for a specific Group:
IPX Serialization Filtering is now enabled on all WAN routing services
Disabling IPX Serialization Filtering
Follow the steps below to disable IPX Serialization Packet Filtering.
1. Enter
ipxserialf.
A screen similar to the following displays:
View the current status of all WAN routing services? (y or n) (n) :
Enter y if you do want to see the current filtering status. Enter n (or press <Enter>) if you
entered this command by mistake or if you don’t need to see the current status.
2. A screen similar to the following displays:
Group IPX Serialization Filtering
---------- ---------------------------------------
3 Enabled
4 Enabled
Enter Group (default: all WAN) :
This screen shows the WAN routing Groups that exist in the switch and the current status
of the IPX Serialization packet filtering for these groups.
Enter a Group number to proceed to disable IPX Serialization filtering for that Group.
Or, just press
Enter to select to proceed to disable filtering for all WAN routing services.
3. The following prompt displays:
Enable IPX Serialization Filtering? (y or n) (n) :
Enter n (or press <Enter>) to select to disable Serialization Filtering.
4. The following prompt displays:
Disable IPX Serialization Filtering on all WAN routing services? (y or n) (n) :
This prompt requires you to verify that you want to disable filtering. This example prompt
asks if you want to disable filtering on all WAN routing services. If you had entered a
specific Group number, the prompt would refer to that particular Group.
Enter
y to disable IPX Serialization Filtering.
5. A message will appear indicating that IPX Serialization Filtering is disabled, either on all
WAN routing services or for a specific Group:
IPX Serialization Filtering is now disabled on all WAN routing services