Filter
Top Products
Defining and Configuring AutoTracker Policies
Page 20-17
4. The following prompt displays:
Enter the port in the form of slot/interface:
Enter the switch port to which this device must be attached. If the device is not attached
to this port, it will not be included in this mobile Group or AutoTracker VLAN. You should
first enter the slot for the module, then a slash (/), then the port number.
If you selected binding policy 1 or 5, then continue with step 5. If you selected binding
policy 2 or 6, then continue with step 6. If you selected binding policy 3, then continue
on with step 7.
5. The following prompt displays:
Enter the IP address:
Enter the IP address for the device. If the device does not have this IP address, it will not
be included in this mobile Group or AutoTracker VLAN.
If you selected binding policy 1 or 4, continue with step 6. If you selected binding policy
5, continue with step 8.
6. The following prompt displays:
Enter the Canonical MAC address in AABBCC:DDEEFF format:
Enter the MAC address for the device. If the device does not have this MAC address, it will
not be included in this mobile Group or AutoTracker VLAN.
If you selected binding policy 1, 4, or 6, then continue with step 8. If you selected bind-
ing policy 2, then continue with step 7.
7. The following prompt displays:
Select Protocol:
1. IP
2. IPX
3. DECNET
4. APPLETALK
5. Protocol specified by ether-type
6. Protocol specified by DSAP and SSAP
7. Protocol specified by SNAP
Enter protocol type (1):
Enter the number for the protocol that will be used to define this binding policy. Numbers
are listed next to the protocol names. By selecting a specific protocol, you are indicating
that a device with the MAC address you specified previously that are attached to the
switch port you specified previously, and with traffic using this protocol will be assigned
to this mobile group or AutoTracker
VLAN. You can select the IP, IPX, DECNET, and APPLE-
TALK
protocols by entering 1, 2, 3, or 4, respectively.
♦ Note ♦
ARP (address resolution protocol) is included as IP.
DDP (datagram delivery protocol) and AARP (Apple-
Talk
ARP) are included as AppleTalk. DECNET is
DECNET Phase IV traffic only.