Filter
Top Products
Chapter 9: Additional Access Point Features
274
To erase the contents of the memory card, enter:
FE APP:
FFR
Purpose: Runs a program f, from a location s.
Syntax: FFR f (s)
where:
f is the program name.
s is the optional segment location of the program.
Example: To run program UAPBOOT.PRG from the flash memory
segment, enter:
FFR UAPBOOT.PRG 1
FI
Purpose: Reinitializes the access point file system. If the access point file
system or a file segment becomes corrupt, use this command to reset it.
Syntax: FI (s)
where s is the optional number of the segment to be reinitialized. You can
use any segment number (1, 2, 3, or 4) to specify the one flash memory
segment on the access point.
FX
Purpose: Downloads a file using Ymodem batch protocol into the flash
segment that is specified by s.
Syntax: FX s
where s is destination segment. You can use any segment number (1, 2,
3, or 4) to specify the one flash memory segment on the access point.
HDW
Purpose: Loads the FPGA configuration file into the access point. If you
are directed to change the FPGA firmware in the access point, use this
command.
Syntax: HDW f (s)