Filter
Top Products
AT-WA7500 and AT-WA7501 Installation and User’s Guide
73
5. From the menu, click DHCP Server Setup. The DHCP Server Setup
screen appears.
6. Configure the DHCP server. For help, see the next table.
7. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 46.
Table 16. DHCP Server Setup Parameter Descriptions
Parameter Explanation
Low Address Enter the low IP address in the range of IP
addresses available to the DHCP server for
distribution to DHCP clients.
If these addresses are not on the same subnet as
the access point, the access point will perform
Network Address Translation (NAT) for the clients
to which it grants IP addresses.
High Address Enter the high IP address in the range of IP
addresses available to the DHCP server for
distribution to DHCP clients.
If these addresses are not on the same subnet as
the access point, the access point will perform
Network Address Translation (NAT) for the clients
to which it grants IP addresses.