Filter
Top Products
Chapter 2: Virtual Chassis Stacking
46
Specifying Ports in the Command Line Interface
The command line interface in the management software on the switch
has a parameter that you use to specify the individual ports. The
parameter is the PORT parameter and Figure 17 shows its format.
Figure 17. PORT Parameter in the Command Line Interface
The first number is the switch’s ID number. The ID numbers of switches in
a stack are displayed on their ID LEDs. You can also view the ID numbers
with the SHOW STACK command in the command line interface.
The module ID value is used with multi-module products. This value does
not apply to the x510 Series switches and should always be 0.
The third value is a port number on the switch. You may specify only one
port number in a PORT parameter, but you may specify more than one
PORT parameter in many of the commands where the parameter is
supported.
Here is an example of the PORT parameter. It uses the INTERFACE
command to enter the Port Interface mode for ports 15 and 17 on the
switch with ID 2:
awplus> enable
awplus# configure terminal
awplus(config)# interface port2.0.15,port2.0.17
For instructions on the command line interface and the PORT parameter,
refer to the Software Reference: AlliedWare Plus Operating System for
x510 Series.
port1
.
0
.n
Module ID
Port Number
Stack ID