Filter
Top Products
Chapter 6: Verifying the Status of VCStack and Activating VCStack
88
4. Enter the CONFIGURE TERMINAL command to move to the Global
Configuration mode, as shown in Figure 50.
Figure 50. Moving to the Global Configuration Mode with the CONFIGURE
TERMINAL Command
5. Enter the STACK ENABLE command to activate VCStack on the
switch, as shown in Figure 51 on page 88:
Figure 51. Activating VCStack with the STACK ENABLE Command
6. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 52.
Figure 52. Returning to the Privileged Exec Mode with the EXIT Command
7. Enter the WRITE command to save your change, as shown in
Figure 53.
Figure 53. Saving the Change with the WRITE Command
Note
If this is the initial management session of the switch, the WRITE
command automatically creates in flash memory a new
configuration file called DEFAULT.CFG in which it stores your
configuration change. You may change the name of the file or
designate a different file after you create the stack.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
awplus(config)# stack enable
% The device needs to be restarted for this change to take effect.
awplus(config)#
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#