Filter
Top Products
Configuration - Protocols Page
65
UDM-0404 Endeleo Multi-Format Distribution Hub
6. Click Add to create the new protocol.
7. Repeat if necessary for other serial commands which are to be stored under this protocol name.
Once complete, the protocol can be assigned to relevant devices.
Updating the UDM Receiver With the Serial Protocol
The UDM-RX02 Receiver which will issue the relevant serial commands to the device must be
connected to the UDM-0404’s relevant port (via Cat5/e/6 cable). Once the Serial Protocol and
commands have been created, follow these steps to update the connected UDM Receiver with the new
protocol:
1. On the Status page (see FIG. 17 on page 27), click on the port number (hyperlink) to which the
serial device is attached. This invokes the Port Configuration options for the selected Port.
2. Click on the Protocol drop-down menu (FIG. 91).
3. Select the Serial protocol which this UDM Receiver will download. This may take a few minutes
depending on how many commands are within the protocol.
4. A message will appear saying “Loading Protocol – Please wait”. Once this has disappeared the
Serial protocol has been downloaded to the UDM Receiver. Commands can now be sent from the
Hub WebConsole to the serial device.
It is presumed that the serial device connected to the Endeleo RX has the
appropriate serial settings as described and the correct serial cable/pinouts
configured in order to function correctly with the Receiver.
Remember the serial commands are stored within the UDM Receiver.
It is the Endeleo Receiver which will issue the serial command over the serial cable
connected between the Receiver and the device.
FIG. 91 Port Configuration options - Protocol drop-down menu
Select the Serial protocol to
download to the UDM Receiver
connected to this Port