Filter
Top Products
Configuration - Protocols Page
67
UDM-0404 Endeleo Multi-Format Distribution Hub
4. Click on Step 1 (FIG. 95).
5. A message saying Press key on remote will appear (FIG. 96).
6. Click the key on the device’s remote control which will manage the action Power On.
7. Click on Step 2 to repeat the process for this command.
8. A message saying Press key on remote will appear. Click the key on the device’s remote control
which will manage the action Power On.
Updating the UDM Receiver With the IR Protocol
1. Ensure the Infrared Protocol has been created previously.
2. Click on the Status page.
3. Click on the port number hyperlink which the device is attached to. It is the Receiver which will
transmit the IR command to the devices IR interface.
4. Once the port properties become visible click on the arrow to the right of the Protocol field.
5. Select the IR protocol which this Receiver will download. This may take a few minutes depending
on how many commands are within the table.
6. A message will appear saying “Loading Protocol – Please wait” once this has disappeared the IR
protocol has been downloaded to the RX device. IR commands can now be sent from the Hub Web
pages to the device.
Ensure the device’s remote control is pointing to the IR sensor located at the front of
the UDM-0404 when performing key presses. If not the key presses may not be
stored in the UDM-0404.
FIG. 95 Capturing IR Protocol - Step 1
FIG. 96 Capturing IR Protocol - "Press key on remote"
The IR learning process requires that the command on the device’s remote is learned
twice (i.e the same remote control command needs to be repeated at Step 2).
A UDM-RX01/02 Receiver, which will issue the relevant IR commands to the device,
must be connected to the relevant port via a Cat5/e/6 cable. Remember the IR
commands are stored within the Receiver.