Filter
Top Products
Configuration - Protocols Page
66
UDM-0404 Endeleo Multi-Format Distribution Hub
Creating and Learning an IR Protocol
IR protocols can be learned by the UDM-0404 by using the device’s remote control to program its
commands into the UDM-0404. This is performed via options in the Protocols page.
The UDM-0404 can learn between 8 and 25 IR commands, depending on the command length and
protocol used.
IR Learning with a Device’s Remote Control
1.
In the Protocol page, open the IR protocol drop-down menu, and select New (FIG. 92).
This action invokes two additional fields: Name and Initialise (FIG. 93):
2. Name the IR protocol appropriately, and click on Initialise.
3. Select the action which is to be performed from the Action drop down menu (e.g. vol up - FIG. 94).
A new table for this device’s Serial control is what is actually being created. When the
administrator decides to create further commands particular to this serial device they
will be stored within this table e.g power off, power on. If new commands are to be
created in future ensure the correct Serial Protocol has been selected before defining
new commands to ensure commands are stored in the correct table. There is one
protocol/table per UDM Receiver.
The device’s own remote control can still be used locally at the device to control the
device.
FIG. 92 IR Protocol drop-down menu
FIG. 93 Creating a new IR protocol
FIG. 94 IR protocol - Action drop-down menu