APC AP9631 Network Card User Manual


 
71UPS Network Management Card 2 User’s Guide
Administration: Notification
Event Actions
Path: Administration > Notification > Event Actions > options
Types of notification
You can configure event actions to occur in response to an event or group of events. These actions notify
users of the event in any of several ways:
Active, automatic notification. The specified users or monitoring devices are contacted directly.
E-mail notification
–SNMP traps
APC Remote Monitoring Service
Syslog notification
Indirect notification
Event log. If no direct notification is configured, users must check the log to determine which
events have occurred
You can also log system performance data to use for device monitoring. See “Data
log” on page 52 for information on how to configure and use this data logging
option.
Queries (SNMP GETs)
For more information, see “SNMP” on page 67. SNMP enables an NMS to
perform informational queries. For SNMPv1, which does not encrypt data before
transmission, configuring the most restrictive SNMP access type (READ) enables
informational queries without the risk of allowing remote configuration changes.
Configuring event actions
Notification parameters. For events that have an associated clearing event, you can also set the
following parameters as you configure events individually or by group, as described in the next two
sections. To access the parameters, click the receiver or recipient name.
Parameter Description
Delay x time before
sending
If the event persists for the specified time, notification is sent. If the condition clears
before the time expires, no notification is sent.
Repeat at an
interval of x time
The notification is sent at the specified interval (e.g., every 2 minutes).
Up to x times During an active event, the notification repeats for this number of times.
Until condition
clears
The notification is sent repeatedly until the condition clears or is resolved.