Filter
Top Products
23
3.3.2 Router Configuration Mode
Router configuration commands are used to configure an IP routing protocol and always follow a router
command. To list the available router configuration keywords, enter the
router
command followed by a
space and a question mark (?) at the global configuration prompt.
Router(config)# router ?
ospf Open Shortest Path First
rip Routing Information Protocol (RIP)
Router(config)# router
In the following example, the router is configured to support the Routing Information Protocol (RIP). The new
prompt is Router(config-rip-router)#.
Router(config)# router rip
Router(config-rip-router)# ?
default-information Control distribution of default route
default-metric Set a metric of redistribute routes
distance Administrative distance
distribute-list Filter networks in routing updates
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
help Description of the interactive help system
neighbor Specify a neighbor router
network Enable routing on an IP network
no Negate a command or set its defaults
offset-list Modify RIP metric
passive-interface Suppress routing updates on an interface
quit Exit current mode and down to previous mode
redistribute Redistribute information from another routing protocol
timers Adjust routing timers
version Set routing protocol version
Router(config-rip-router)#
To exit router configuration mode and return to global configuration mode, enter the exit command. To exit
configuration mode and return to privileged EXEC mode, use the end command or press Ctrl-Z.
3.3.3 Route-Map Configuration Mode
Use the route-map configuration mode to configure the routing table and the source and destination
information. To access and list the route-map configuration commands, enter route-map command at the
global configuration mode.
In the following example, a route map named mymap is configured. The new prompt is Router(config-route-
map)#. Enter a question mark (
?
) to list
route-map
configuration commands.
Router(config)# route-map mymap permit 30
Router(config-route-map)# ?
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
help Description of the interactive help system
match Match values from routing table
no Negate a command or set its defaults
on-match Exit policy on matches
quit Exit current mode and down to previous mode
route-map Create route-map or enter route-map command mode
set Set values in destination routing protocol
Router(config-route-map)#
To exit route-map configuration mode and return to global configuration mode, enter the
exit
command. To
exit configuration mode and return to privileged EXEC mode, use the end command or press Ctrl-Z.