Filter
Top Products
Usage
Click System - Usage to view memory and Flash usage.
Network
Click Network to view and configure the network options for Hostname, DNS, IPv6, Bonding,
IPv4 and IPv6 static routes, Hosts, Firewall, IPSec (VPN) and SNMP.
Settings
Click Network - Settings to make changes to the configured network settings: Hostname, DNS,
Bonding, IPv4 Multiple Routing Table.
NOTE: IPv4MultipleRoutingTableallow administrator toconfiguretwonetworksonefor eachinterface(EHT0
andETH1) withitsown defaultgateway.
Devices
An administrator can select, enable and configure the IP addresses assigned to the network
interfaces and view the MAC address. Besides the two standard Ethernet interfaces, the list of
network interfaces includes entries for any Ethernet PC cards that may be installed.
To configure a network device:
1. Select Network - Devices. The Devices screen appears with a list of network interfaces and
their status (enabled or disabled).
2. Click the name of the network device to configure.
3. Select the status (either Enabled or Disabled) from the drop-down menu.
4. Select one of the following IPv4 method options:
• Select DHCP to have the IPv4 IP address set by the DHCP server.
• Select Static to enter the IPv4 IP address, subnet mask and gateway address manually.
• Select IPv4 address unconfigured to disable IPv4.
5. Select one of the following IPv6 method options:
• Select Stateless if the link is restricted to the local IP address.
• Select DHCPv6 to have the IPv6 IP address set by the DHCP server.
• Select Static to enter the IPv6 IP address and prefix length manually.
• Select IPv6 address unconfigured to disable IPv6.
6. Select the Ethernet Mode for the built-in interface (ETH0 and ETH1).
30 Cyclades™ ACS 6000 Advanced Console Server Installation/Administration/User Guide