Filter
Top Products
2. Click the Set Power button and use the drop-down menus to configure the physical
settings.
3. Click Next or click the Power link.
a. Use the drop-down menu to select the PDU type.
b. Check the box to enable speed auto detection.
c. Configure the polling rate.
d. For Avocent/Cyclades PDUs, enter the power cycle interval and then use the drop-
down menus to enable or disable Syslog, Buzzer and SW Overcurrent Protection.
4. Click Save.
To configure or edit auxiliary port with a connected modem:
1. Select Ports - Auxiliary Ports.
2. Click the Set Dial-In button and use the drop-down menus to configure the Dial-in
settings.
3. Configure the PPP parameters (address, authentication, and so on).
4. Click Save.
CAS Profile
An administrator can configure settings for auto discovery and for auto answer features.
Auto discovery
The auto discovery feature will discover the target name of the server connected to the serial
port. This name will be used as the alias of the serial port.
When auto discovery is active for a certain serial device, upon target connection (DCD ON
event), the appliance will send probe strings and start analyzing target device answers using
regular expressions. There will be predefined probe and match strings as well as customer-
defined ones.
For each probe string sent, all regular expressions defined by the match strings will be tested.
After the last cycle, the sequence restarts. This procedure will run for a certain period (given by
the auto discovery time-out parameter) or until the target is successfully detected. If auto
discovery fails, the target name will be reset to the configured target name or to the
corresponding unique default target name.
NOTE: Theconfiguredtarget namewillbeusedonlyafter theautodiscoveryprocessfails.
Chapter 3: Accessing the Console Server via the Web Manager 45