Filter
Top Products
6. Web Interface
Image 6-28
Integration, Polycom
3. To enable Polycom integration, check the check box next to Enable Polycom Integration (3).
The user is asked to fill in the IP address or hostname (5) of the target Polycom unit together with the Telnet port
1
(6) that allows
sending API commands.
4. Click Apply (7).
Once the integration is enabled, the ClickShare Base Unit will enter to the standby mode if there is no sharing ClickShare Button.
As soon as the connection is established between the two systems
2
, the ClickShare Base Unit sends “notify vidsourcechanges”
API command to the Polycom unit. From
that moment on, if content coming from ClickShare is taken out from the display by the
Polycom unit , all ClickShare Buttons that are currently sharing content will go to Ready to S hare mode and the ClickS hare Base
Unit will go to the standby mode. The client can start sharing again by clicking to their buttons and their content will be shown on
the display.
In c ase of an error, the LED will turn to red and an error string will be shown.
Disable the connection
1. Uncheck the check box next to Enable Polycom Integration.
2. Click Apply.
The ClickShare Base Unit will send “nonotify vidsourcechanges ” API command to the Polycom unit and the c onnection will be
closed.
1. Telnet port is set to 24 by default.
2. Since establishing the connection may take some time, refreshing the current page may be necessary to see the latest status of the connection.
58 R5900004 CLICKSHARE 19/08/2014