Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
11
Radius Configuration
Radius is used to authenticate logins for the serial and the network ports if passwords and user names
are enabled on the DS. If the Radius server rejects either the username or password or does not
respond, the DS will display “Invalid Password”.
TACACS Configuration
TACACS can be used to authenticate logins for the serial port, the network port, and modem. When a
telnet / SSH session (or rs232 session) is started the Host module will prompt for the username and
password. The Host will communicate with the TACACS server. If the server verifies the username
and password, the Host will display the menus. If the server rejects the username and password or
does not respond the Host will display the reason why the login failed.
Network Port Configuration
IMPORTANT: For network access, enable Telnet and configure the IP addresses, Subnet
Mask, and Gateway Address, or enable the DHCP. The module must be reset for network
changes to take effect.
Figure 5
Network setup :
Ethernet Address................ 00:C0:48:00:01:FD
IP Address...................... 70.150.140.89
Subnet Mask..................... 255.255.255.224
Default Gateway................. 70.150.140.65
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Enabled
Break Length (msecs): 350
DHCP is Disabled Telnet is Enabled SSH is Enabled
SSH host keys are set to factory default
IP Address........................1
Subnet Mask.......................2
Gateway Address...................3
Inactivity Timeout................4
Carriage Return Translation.......5
Break Length......................6
DHCP Enable/Disable...............7
Telnet Enable/Disable.............8
SSH Enable/Disable................9
SSH Host Key Generation...........10
IP Filter Configuration...........11
SNMP Configuration................12
Web Server Configuration..........13
Exit..............................X,CR
Enter Request :