Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
14
Detail Operations and Configurations
NOTE: Depending on the DS-Series model, the menus may vary according to the number of DS74
modules installed in the unit. If this is not an initial set-up and Password has already been enabled, you
are prompted to login. After logging in successfully, invoke the main menu by sending the attention
character five times (;;;;;).
NOTE: Password feature is case sensitive. Default is ‘root/baytech’.
Main Screen
DS62-MD4
IMPORTANT: The Factory default serial communications parameters are 9600 bps, 8 data
bits, 1 stop bit, and no parity.
With a proper connection to the unit upon power-up or unit reset, the following initialization and
Status menu will be displayed except the number of outlets will be dependent on the specific DS unit:
NOTE: Only the Administrator user will see the configuration option.
IMPORTANT: If you get the following message after selecting the ‘Configure’ option, the
other port has the configuration option selected.
IMPORTANT: Once you make a change to any of the Configuration options, you have to
back out of the Configuration menu and will be asked to ‘Accept’ changes. If you type ‘Y’ for
YES and press <cr>, the changes take effect immediately for the serial port. For the Ethernet
port you must do a Unit Reset to get the changes to take effect.
Configuration mode in use.
DS-Series - F 2.10.05 (C) 2005 Bay Technical Associates
Module Name: DS62-MD4
Module: 1
Attention Character: ;
Device A (2 ,1).........1
Device B (2 ,2).........2
Device C (2 ,3).........3
Device D (2 ,4).........4
DS-RPC (5 ,1).........5
Status..........................S Current configuration
Configure.......................C Make Changes
Unit Reset......................RU Resets the DS-Unit, terminates internal &
external modem connections, allow 10
seconds for reset.
Logout..........................T
Enter Request :c