Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
24
Enter an incorrect port the DS displays:
Delete User
Select D), press <cr>, and type the number of the user to be deleted:
NOTE: the ‘root’ user can not be deleted.
Direct Port Connection
This will allow the user to be connected directly to a DS serial port, as determined by the TCP port,
starting at TCP port 50001.
Radius Configuration
Radius is used to authenticate logins for the serial and the network ports if passwords and user names
are enabled on the DS. If the Radius server rejects either the username or password or does not
respond, the DS will display “Invalid Password”.
Select “Radius Enable” to turn on or off radius authentication. If enabled, the primary radius server
address must be specified.
Enter port list (mod.port,mod.port), ALL for all ports, NONE for no ports:
2.1,3.2,3.3
Port access for user1
X = has access
| mod 2 | mod 3 |
| 1234 | 1234 |
X XX
Enter port list (mod.port,mod.port), ALL for all ports, NONE for no ports:
1.2
Input Error
From menu above, enter number for user to delete>1
Direct Port Connection is.........Disable
d
Enable ? (Y/N), CR for no change) :
Radius Enable....................1 Enable Radius Login
Radius Server Address............2 Radius server IP address 0.0.0.0 form
Radius Backup Server Address.....3 Backup Radius server IP address
Radius Secret....................4 Radius secret key (16 char max)
Enable DS62 usernames as backup..5 As written
Radius Login Timeout.............6 Enter timeout, in seconds(>=5 and <=30)
Exit.............................X,CR