DS62-Network, DS62-MD4 Network/Modem Host Module
47
Route Setup
Every TCP/IP client machine, regardless of operating system, needs to make decisions about where to
send a packet after it has been addressed. The route table is the network map that tells your Baytech
product how to deliver the packet to its network addressee.
• Destination, is a list of routes. “0” represents any number.
• Gateway, is the network gateway for the route. The connection point to your company network.
• Genmask, It defines how closely an address must match the network destination, octet by octet,
to use the route.
• Iface, is the interface used to reach the network gateway, in this case the interface is the
Baytech network card.
Processes
Processes are a list of commands used by the firmware to operate.
Type ‘T’, and the unit responds:
Kernel IP routing cache
Source Destination Gateway Flags Metric Ref Use Iface
Press ENTER to continue
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.2.0 * 255.255.255.0 U 0 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
Press ENTER to continue
PID PORT STAT SIZE SHARED %CPU COMMAND
1 S 133K 0K 0.2 init
2 S 0K 0K 0.0 keventd
3 R 0K 0K 0.0 ksoftirqd_CPU0
4 S 0K 0K 0.0 kswapd
5 S 0K 0K 0.0 bdflush
6 S 0K 0K 0.0 kupdated
11 R 43K 0K 99.3 baytechd
12 S 13K 0K 0.1 mdmautologind
13 S0 S 13K 0K 0.1 /bin/autologind
14 S 14K 0K 0.0 /bin/inetd
17 S 133K 0K 0.1 DScmdd
18 S 13K 0K 0.0 snmppolld
19 S 1833K 0K 0.0 snmpd
25 S0 R 71K 0K 1.0 ds62
Strike T, CR to terminate a connection/process, CR to continue :
Enter PID process to terminate, CR: