Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
25
Select “Radius Server Address” to assign a specific radius server IP addresses.
Select “Radius Backup Server Address” to assign a specific backup server IP addresses.
Select “Radius Secret” to assign a shared radius secret. A secret can be up to 16 characters and must
be exactly the same as the secret stored on the server.
Select “Enable DS62 Usernames as Backup” to allow an unsecured access in case all specified radius
servers are unavailable.
Select “Radius Login Timeout” a specific amount of time the DS will wait for a response from the
radius server after sending the login message to the radius server. A timeout on a radius response is
treated, per RFC specifications, as a rejection from the radius server.
TACACS Configuration
TACACS can be used to authenticate logins for the serial port, the network port, modem or all three.
When a telnet / SSH session (or rs232 session) is started the Host module will prompt for the
username. After entering the username the Host will prompt for the password. After the password is
entered the Host will communicate with the TACACS server. If the server verifies the username and
password, the Host will display the menus. If the server rejects the username and password or does not
respond the Host will display the reason why the login failed.
Setting Up TACACS
Radius login is...................Disable
d
Enable ? (Y/N), CR for no change) :
Radius Server IP Address is: 0.0.0.0
Enter radius server address in dotted decimal form :
Radius Backup IP Address is: 0.0.0.0
Enter radius server address in dotted decimal form :
Radius secret is: HardlyASecret
Enter radius secret (16 chars max).
:
DS62 usernames as backup login is Disable
d
Enable ? (Y/N), CR for no change) :
Radius response timeout is 5 seconds
Enter timeout, in seconds ( >=5 and <=30 ) :