Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
28
IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and
Gateway Address. The module must be reset for network changes to take effect.
IP Address
The IP address is the network address assigned by your network manager for your network. The IP
Address consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed
before the DS is accessible via the network.
Select 1) to enter the IP Address. Failure to enter the address in the decimal form causes the DS to
display the following until it is entered correctly. Default Module IP Address is 0.0.0.0.
NOTE: There should be no active connections while configuring the DS module. The unit
should be reset upon completion of configuration.
Subnet Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the DS to
determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of
four bytes, each byte ranging from 0 to 255. This parameter must be programmed before the DS-
Series can be accessed through the network.
Network setup :
Ethernet Address................ 00:C0:48:00:01:FD
IP Address...................... 70.150.140.89
Subnet Mask..................... 255.255.255.224
Default Gateway................. 70.150.140.65
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Enabled
Break Length (msecs): 350
DHCP is Disabled Telnet is Enabled SSH is Enabled
SSH host keys are set to factory default
IP Address........................1
Subnet Mask.......................2
Gateway Address...................3
Inactivity Timeout................4
Carriage Return Translation.......5
Break Length......................6
DHCP Enable/Disable...............7
Telnet Enable/Disable.............8
SSH Enable/Disable................9
SSH Host Key Generation...........10
IP Filter Configuration...........11
SNMP Configuration................12
Web Server Configuration..........13
Exit..............................X,CR
Enter IP address in dotted decimal form :