Filter
Top Products
DS62-Network, DS62-MD4 Network/Modem Host Module
32
Select D), Delete Rule to delete a specific rule. The DS displays:
SNMP Configuration
Selecting the SNMP Configuration and the Host Module respond:
Depending on the firmware, SNMP Configuration allows the admin to control whether or not a user
has Read/Write access or Read access only. It also allows the admin to control which IP addresses are
allowed to receive a host trap, and simply whether to enable or disable the entire SNMP function.
IMPORTANT: You will need some knowledge of SNMP protocols in order to get the Baytech
device to work with your SNMP program. Information provided is for the SNMP Agent only.
Baytech Support will assist with the Agent part only. For SNMP Manger assistance refer to the
vender manual or contact the vender of the SNMP software you are using.
NOTE: There are a number of shareware MIB Browsers that can be downloaded from the
internet to make changes and receive traps for a quick verification test.
NOTE: To use the SNMP functions you need to download the MIB from Baytech’s web site,
www.baytech.net
. Look under Tech Support, Docs and Downloads.
IMPORTANT: Changes do not take effect until they are saved when you leave the
configuration menu. The DS will display:
Are you sure you want to delete all filters? (Y/N)
Enter Request :y
All filers have been deleted.
Delete Filter Menu
Enter rule number to delete rule, 'M' to view
more rules, or 'X' to exit menu.
Rule Num Ip Address Target
1 70.150.140.95 DROP
2 70.150.140.96 ACCEPT
3 70.150.140.99 ACCEPT
Enter Request :2
Filter Rule 2 deleted.
SNMP Trap Host 1 Address..........1
SNMP Trap Host 2 Address..........2
SNMP Trap Host 3 Address..........3
SNMP Trap Host 4 Address..........4
SNMP Read-Only Community..........5
SNMP Read-Write Community.........6
SNMP Enable.......................7
SNMP v3 Only Enable...............8
SNMP Authentication Traps Enable..9
Exit..............................X,CR