Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 163
Chapter 3: Configuration
3.21 Trap Event Severity
This function is used to set a Alarm trap and get the Event log. The Trap Events Configuration function is used to enable the
switch to send out the trap information while pre-defined trap events occurred.
Web Interface
To configure the Trap Event Severity Configuration in the Web interface:
1. Click Configuration, Trap Event Severity Configuration.
2. Scroll to select the Group name and Severity Level.
3. Click Save to save the setting.
4. To cancel any changes before saving, click the Reset button to revert to previously saved values.
Figure 3-92. The Trap Event Severity Configuration screen.
Parameter Description
• Group Name: The field describes the Trap Event definition.
• Severity Level: Select the event type with “Emerg“, “Alert“, “Crit“, “Error“, “Warming“, “Notice“, “Info“ and “Debug”.
• Buttons:
- Save: Click to save changes.
- Reset: Click to undo any changes made locally and revert to previously saved values.
LGB1108A