Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 167
Chapter 4: Security
Parameter Description
• Mode of IP Source Guard Configuration: Enable the Global IP Source Guard or disable the Global IP Source Guard. All
configured ACEs will be lost when the mode is enabled.
• Port Mode Configuration: Specify on which ports IP Source Guard is enabled. Only when both Global Mode and Port Mode
on a given port are enabled is IP Source Guard enabled on that port.
• Max Dynamic Clients: Specify the maximum number of dynamic clients that can be learned on given port. This value can be
0, 1, 2 or unlimited. If the port mode is enabled and the value of max dynamic client is equal to 0, it means it only allows the IP
packets forwarding that are matched in static entries on the specific port.
• Buttons:
- Save: Click to save changes.
- Reset: Click to undo any changes made locally and revert to previously saved values.
4.1.2 Static Table
This section describes how to configure the Static IP Source Guard Table parameters of the switch. The Static IP Source Guard
Table enables you to configure and to manage the entries.
Web Interface
To configure a Static IP Source Guard Table Configuration in the Web interface:
1. Click “Add new entry.”
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click “Save.“
Figure 4-2. The Static IP Source Guard Table screen.
Parameter Description
• Delete: Check to delete the entry. It will be deleted during the next save.
• Port: The logical port for the settings.
• VLAN ID: The VLAN ID for the settings.
• IP Address: Valid source IP address.
LGB1108A