Filter
Top Products
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 185
Chapter 4: Security
- Multi 802.1X
- MAC-based Auth.
• Last Supplicant/Client Info: Information about the last supplicant/client that attempted to authenticate. This information is
available for the following administrative states:
- Port-based 802.1X
- Single 802.1X
- Multi 802.1X
- MAC-based Auth.
Selected Counters
• Selected Counters: The Selected Counters table is visible when the port is in one of the following administrative states:
• Multi 802.1X
• MAC-based Auth.: The table is identical to and is placed next to the Port Counters table, and will be empty if no MAC address
is currently selected. To populate the table, select one of the attached MAC addresses from the table described below.
Attached MAC Addresses
• Identity: Shows the identity of the supplicant, as received in the Response Identity EAPOL frame. Clicking the link causes the
supplicant's EAPOL and Backend Server counters to be shown in the Selected Counters table. If no supplicants are attached, it
shows No supplicants attached.
This column is not available for MAC-based Auth.
• MAC Address: For Multi 802.1X, this column holds the MAC address of the attached supplicant. For MAC-based Auth., this
column holds the MAC address of the attached client.
Clicking the link causes the client’s Backend Server counters to be shown in the Selected Counters table. If no clients are
attached, it shows No clients attached.
VLAN ID
This column holds the VLAN ID that the corresponding client is currently secured through the Port Security module.
• State: The client can either be authenticated or unauthenticated. In the authenticated state, it is allowed to forward frames on
the port, and in the unauthenticated state, it is blocked. As long as the backend server hasn't successfully authenticated the
client, it is unauthenticated. If an authentication fails for one or the other reason, the client will remain in the unauthenticated
state for Hold Time seconds.
• Last Authentication: Shows the date and time of the last authentication of the client (successful as well as unsuccessful).
• Auto-refresh: Check the auto-refresh box to set the unit to refresh information automatically.
• Icons, upper right of screen (Refresh, Clear): Click to refresh the NAS Statistics information manually. Click Clear to revert
top reviously-saved values.
LGB1108A