Filter
Top Products
2001/10/02
CHAPTER 2 "PCL" - 20
• # = 2 indicates the back face.
If the currently processing page is an odd page, the printer finishes the processing of the page.
If the odd page has already been processed onto the page and the even page has not been processed yet,
this command is ignored.
If the currently processing page is an even page, the printer finishes the processing of the page and attaches
a dummy (white) page.
If both an even and odd page have been processed and the next odd page has not been processed yet, only a
dummy (white) page is attached.
4.1.8. Job separation command (For HL-3260N/2460)
Esc&l1T (27)(38)(108)(49)(84) <1Bh><26h><6Ch><31h><54h>
It is recommended to insert this command at the end of each job.
4.1.9. Reset
EscE (27)(69) <1Bh><45h>
• A printer reset restores the user default environment, deletes any temporary fonts and temporary macros.
• Any pages that have been transmitted are printed out.
• You can also perform a printer reset using the printer’s control panel or remote printer console program (see
the User Guide).
4.1.10. Reset to factory default settings
EscCRFD (27)(13)(70)(68) <1Bh><0Dh><46h><44h>
• This command causes a factory reset to be performed, restoring all the printer’s factory default settings. See
the section “Factory default environment” for a list of the factory default settings.
• You can also perform a factory reset using the printer’s control panel or remote printer console program (see
the User Guide).
4.1.11. Reset to user settings
EscCR!#R (27)(13)(33)#(82) <1Bh><0Dh><21h>#<52h>
• # can be 0, 1 or 2.
• #0 indicates the current settings are restored. Unlike the Esc E reset command, the Esc CR!0R command
resets the input buffer.
• #1 indicates the user settings 1 are restored, if the printer supports multi user settings.
• #2 indicates the user settings 2 are restored, if the printer supports multi user settings.
• Depending on the model, you may be able to lock the control panel settings ("SETTING LOCK=ON"). In that
case, parameters 1 and 2 are ignored.
4.1.12. Printer self test
Escz (27)(122) <1Bh><7Ah>
A printer self test causes a test sheet to be printed out to show that the machine is working properly. Depending
on the model, you may also see the test pattern for HRC setting.
4.1.13. Exit current emulation mode
Esc%-12345X (27)(37)(45)(49)(50)(51)(52)(53)(88)
<1Bh><25h><2Dh><31h><32h><33h><34h><35h><58h>
• When the printer receives this command, all page data already received is printed out.
• All settings are reset to the user settings.
• Exits the current emulation mode.