Filter
Top Products
Confidential
1-25
Error code 9D
Registration
Registration failed. See Troubleshooting chapter in User’s Guide.
Incorrect sensor measurement value when implementing auto color registration from the control
panel
User Check
- Check if there is a scratch, dirt or the like on the belt unit. If there is, replace the belt unit with
a new one.
Step Cause
Remedy
1 Invisible damage on belt unit Check the registration mark sensor performance
following the procedure described in “Maintenance
mode 75”. If any problem occurs, replace the belt unit.
2 Harness connection failure of
registration-mark sensor PCB
ASSY
Check the harness connection of the registration-
mark sensor PCB ASSY and reconnect it.
3 Registration-mark sensor
PCB failure
Replace the registration-mark sensor PCB ASSY.
4 Transfer HVPS PCB unit
failure
Replace the transfer HVPS PCB unit.
5 Engine PCB failure Replace the engine PCB ASSY.
Error code A2
Document Jam.
Clear the scanner jam, then press the Stop Key.
The document is too long. (During scanning, 90 cm or longer of a document is detected.)
User Check
- Check if the document is jammed in the ADF. If jammed, remove it.
Step Cause
Remedy
1 Document rear actuator not
operating smoothly or
catching in some position.
Correct smooth operation and that there is no
catching of document rear actuator.
Error code A3
Document Jam.
Clear the scanner jam, then press the Stop Key.
Document rear sensor is not turned on when feeding the document.
User Check
- Check if the document is jammed in the ADF. If jammed, remove it.
Step Cause
Remedy
1 Document rear actuator not
operating smoothly or
catching in some position.
Correct smooth operation and that there is no
catching of document rear actuator.
2 Document rear sensor failure. Replace the document rear sensor.